Cars & Vehicles Auto Parts & Maintenance & Repairs

How to Install a Jeep Unlimited Hardtop

    • 1). Turn the Jeep Wrangler Unlimited's engine off and open its hood. Disconnect the negative battery cable.

    • 2). Lift the rear section of the Jeep Wrangler Unlimted hardtop onto the rear part of the vehicle. Insert the six bolts into their washers and into the bolt holes on the inside of the hardtop.

    • 3). Place the Nylock nuts onto the other end of the bolts that come through the hardtop and Wrangler side rails. Tighten the six bolts with the Phillips screwdriver.

    • 4). Use the flat-head screwdriver to tighten the four threaded studs in the cockpit cover of the hardtop and place it onto the Jeep Wrangler Unlimited's cockpit. Place the threaded studs into the holes of the Jeep Wrangler Unlimited's roll-bar. Tighten the four turn knobs on the ends of the threaded studs.

    • 5). Press the weather strip onto the edge of the tailgate. Reconnect the negative battery cable and close the Jeep Wrangler Unlimited's hood and tailgate.

Leave a reply